Read[1]|2|3|4[:Scalar][:Power:ac]:Ratio? [<Expected_Value>[,<Resolution>[,<Source List>]]] - Agilent Technologies N1911A Programming Manual

READ[1]|2|3|4[:SCALar][:POWer:AC]:RATio?
[<expected_value>[,<resolution>[,<source list>]]]
This command sets the specified window's measurement function to ratio
mode with relative mode off, aborts then initiates both Channel A and B,
calculates the ratio measurement result and places the result on the bus.
The result is a ratio based measurement and is expressed in the units
defined by UNIT[1]|2|3|4:POWer:RATio.
INITiate:CONTinuous must be set to OFF on both channels, otherwise error –213, "INIT
N O T E
ignored" occurs. If TRIGger:SOURce is set to BUS on either channel, error –214, "Trigger
deadlock" occurs.
Syntax
READ
1
2
3
4
Parameters
Refer to
parameters in this command.
N1911A/1912A P-Series Power Meters Programming Guide
:POW
:SCAL
expected_value
Space
DEF
"Optional Parameters"
Item Description/Default
expected_value The power meter ignores the numeric value
(for the expected entered in this parameter. Any value entered is
power level) treated like DEF.
:AC :RAT
,
resolution
DEF
on page 90 for additional details on the
MEASurement Commands
?
,
source list
Range of Values
sensor dependent
1
DEF
2
141