Memory:catalog Commands - Agilent Technologies N1911A Programming Manual

7 MEMory Subsystem

MEMory:CATalog Commands

These commands are used to query information on the current contents of
a power meter's:
• Sensor calibration tables (8480 Series sensors and N8480 Series
• Frequency dependent offset tables
• Save/recall registers
The following commands are detailed in this section:
MEMory:CATalog[:ALL]?
MEMory:CATalog:STATe?
MEMory:CATalog:TABLe?
258
sensors with Option CFT only)
N1911A/1912A P-Series Power Meters Programming Guide