Service:sensor[1]|2:Corrections:state <Boolean - Agilent Technologies N1911A Programming Manual

SERVice:SENSor[1]|2:CORRections:STATe <boolean>
This command enables/disables the voltage to corrected power conversion.
It applies to E9320 Series power sensors only.
Before setting this command to OFF, you must set the INIT:CONT command to OFF.
N O T E
After setting this command to OFF, you must only run commands relating to the gathering
of ADC values—for example, the SERV:SENS:RADC command.
Syntax
Example
SERV:SENS2:CORR:STAT ON
Reset Condition
On reset, the value is set to ON.
N1911A/1912A P-Series Power Meters Programming Guide
SERV :SENS
:STAT
1 :CORR
2
This command enables the voltage to
corrected power conversion for Channel
B.
SERVice Subsystem
Space
0|OFF
1|ON
?
15
713