Calculate[1]|2|3|4:Limit:fail - Agilent Technologies N1911A Programming Manual

CALCulate[1]|2|3|4:LIMit:FAIL?

This query enters a 1 or 0 into the output buffer indicating whether there
have been any limit failures for the specified window. A limit failure is
defined as CALC[1]|2|3|4:LIMit:FCO? being non- zero. The FCO (fail
counter) can be zeroed using the CALC[1]|2|3|4:LIMit:CLEar command.
• 1 is returned when one or more limit failures have occurred
• 0 is returned when no limit failures have occurred
Syntax
Example
CALC1:LIM:FAIL?
Reset Condition
On reset, the buffer is set to zero for both upper and lower window
measurements.
N1911A/1912A P-Series Power Meters Programming Guide
CALC 1 :LIM
2
3
4
:FAIL ?
This command queries if there have been
any limit failures on the upper
window/upper measurement.
CALCulate Subsystem 3
177