Agilent Technologies N1911A Programming Manual page 162

2 MEASurement Commands
Example
READ1:REL? DEF,1,(@2)
Error Messages
• INITiate:CONTinuous must be set to OFF, otherwise error –213, "INIT
• If TRIGger:SOURce is set to BUS or HOLD, error –214, "Trigger
• If the expected value and resolution parameters are not the same as
134
ignored" occurs.
deadlock" occurs.
the current expected value and resolution settings on the specified
window, error –221, "Settings conflict" occurs.
This command queries the upper
window/upper measurement relative
measurement of Channel B, using the
current sensor range and a resolution of
1.
N1911A/1912A P-Series Power Meters Programming Guide