Agilent Technologies N1911A Programming Manual page 6

In This Guide...
vi
Power Meter Remote Operation
1
that configure the power meter and helps you determine settings to
optimize performance.
MEASurement Commands
2
group of instructions to acquire data using a set of high level instructions.
CALCulate Subsystem
3
subsystem is used to perform post acquisition data processing.
CALibration Subsystem
4
command subsystem is used to zero and calibrate the power meter.
DISPlay Subsystem
5
used to control the selection and presentation of the windows used on the
power meter's display.
FORMat Subsystem
6
used to set a data format for transferring numeric information.
MEMory Subsystem
7
subsystem is used to create, edit and review sensor calibration tables.
OUTput Subsystem
8
subsystem is used to switch the POWER REF output on and off.
PSTatistic Subsystem
9
subsystem is used to configure the settings of Complementary Cumulative
Distribution Function (CCDF), both in table and trace format.
SENSe Subsystem
10
subsystem directly affects device specific settings that are used to make
measurements.
STATus Subsystem
11
subsystem enables you to examine the status of the power meter by
monitoring the "Device Status Register", "Operation Status Register" and
the "Questionable Status Register".
N1911A/1912A P-Series Power Meters Programming Guide
Chapter 1 describes the parameters
Chapter 2 explains how to use the MEASure
Chapter 3 explains how the CALCulate
Chapter 4 explains how the CALibration
Chapter 5 explains how the DISPlay subsystem is
Chapter 6 explains how the FORMat subsystem is
Chapter 7 explains how the MEMory command
Chapter 8 explains how the OUTput command
Chapter 9 explains how the PSTatistic command
Chapter 10 explains how the SENSe command
Chapter 11 explains how the STATus command