Agilent Technologies N1911A Programming Manual page 474

10 SENSe Subsystem
Reset Condition
On reset, the delay is set to 0 seconds.
Query
SENSe[1]]|SENSe2:TRACe:OFFSet:TIME?
The query returns the current delay between the delayed trigger point and
the start of the trace.
Query Example
SENS:TRAC:OFFS:TIME?
Error Messages
• If the command is used when a sensor other than a P- Series or E9320
•
446
power sensor is connected, error –241, "Hardware missing" occurs
If the command is used when an E9320 sensor is connected and set to
AVERage mode rather than NORMal mode, the error –221, "Settings
Conflict" occurs.
This command queries the current delay
between the delayed trigger point and the
start of the trace for Channel A.
N1911A/1912A P-Series Power Meters Programming Guide