Agilent Technologies N1911A Programming Manual page 224

3 CALCulate Subsystem
Example
CALC1:REL:AUTO ONCE
Query
CALCulate[1]|2|3|4:RELative[:MAGNitude]:AUTO?
The query always returns OFF.
Error Message
• If CALCulate:RELative[:MAGNitude]:AUTO is set to ONCE while
• If the value is set to ON error –224, "Illegal parameter value" occurs.
196
SENSe:SPEed is set to 200, error –221, "Settings Conflict" occurs.
This command sets a reference value to be
used in the relative measurement on the
upper window/upper measurement.
N1911A/1912A P-Series Power Meters Programming Guide