Service:sensor[1]|2:Power:average:maximum - Agilent Technologies N1911A Programming Manual

15 SERVice Subsystem

SERVice:SENSor[1]|2:POWer:AVERage:MAXimum?

This query returns the maximum average power that can be measured by
the currently connected sensor. It is applicable to E- Series sensors only.
Maximum average power information is stored in the sensor's EEPROM.
Syntax
Example
SERV:SENS:POW:AVER:MAX?
Error Messages
• If no sensor is connected, error –241, "Hardware missing" occurs.
• If a a sensor other than an E- Series sensor is connected, error –241
• If the E- Series sensor currently connected does not contain the
720
SERV :SENS
"Hardware missing" occurs.
necessary information in EEPROM, error –241 "Hardware missing"
occurs.
1 :POW
2
This query returns the maximum average
power that can be measured by the
E- Series sensor currently connected to
Channel A.
N1911A/1912A P-Series Power Meters Programming Guide
:AVER :MAX
?