Agilent Technologies N1911A Programming Manual page 747

Query Example
SERV:SENS:PCAL?
Error Messages
• If no power sensor is connected, error –241 "Hardware missing" occurs.
• If a a sensor other than an E9320 power sensor is connected, error
• If INIT:CONT is not set to OFF, error –221, "Settings conflict" occurs.
N1911A/1912A P-Series Power Meters Programming Guide
–241 "Hardware missing" occurs.
This command returns the peak path
calibration factor block for Channel A.
SERVice Subsystem
719
15