Memory:table Commands - Agilent Technologies N1911A Programming Manual

7 MEMory Subsystem

MEMory:TABLe Commands

These commands are used to define a sensor calibration table (8480 Series
sensors and N8480 Series sensors with Option CFT only) or a frequency
dependent offset table, and to write to and read data from it.
The following commands are described in this section:
MEMory:TABLe:FREQuency <numeric_value>{,<numeric_value>}
MEMory:TABLe:FREQuency:POINts?
MEMory:TABLe:GAIN[:MAGNitude]
<numeric_value>{,<numeric_value>}
MEMory:TABLe:GAIN[:MAGNitude]:POINts?
MEMory:TABLe:MOVE <character_data>,<character_data>
MEMory:TABLe:SELect <character_data>
278 N1911A/1912A P-Series Power Meters Programming Guide