Agilent Technologies N1911A Programming Manual page 167

Parameters
Refer to
parameters in this command.
N1911A/1912A P-Series Power Meters Programming Guide
"Optional Parameters"
Item Description/Default
expected_value The power meter ignores the numeric value
(for the expected entered in this parameter. Any value entered is
power level) treated like DEF.
resolution A numeric value for the resolution. If it is
unspecified the current resolution setting is used.
If a value is entered it should correspond to the
current resolution setting otherwise an error
occurs.
source list This channel list specifies the channels used to
calculate the difference.
If unspecified and the current window setup is a
difference measurement then this difference
setup is used, otherwise it defaults to Channel
A-B (N1912A) or A-A (N1911A).
1
The mnemonic DEF means DEFault. This is not equivalent to the DEFault parameter used in the
command sub-systems. The parameters must be entered in the specified order. If parameters are
omitted, they default from the right. The parameter DEFault is used as a place holder. Specifying
DEF leaves the parameter value unchanged.
2
When the measurement result is linear this parameter represents the number of significant
digits. When the measurement result is logarithmic 1 to 4 represents of 1, 0.1, 0.01 and 0.001
respectively.
3
N1912A only.
MEASurement Commands
on page 90 for additional details on the
2
Range of Values
sensor dependent
1
DEF
2
1 to 4
1.0, 0.1, 0.01, 0.001
1
DEF
3
(@1),(@2)
3
(@2),(@1)
(@1),(@1)
3
(@2),(@2)
139