Agilent Technologies N1911A Programming Manual page 476

10 SENSe Subsystem
Reset Condition
On reset, the duration is set to 100 µs.
Query
SENSe[1]]|SENSe2:TRACe:TIME?
The query returns the current duration of the trace.
Query Example
SENS2:TRAC:TIME?
Error Messages
• If the command is used when a sensor other than a P- Series or E9320
•
448
power sensor is connected, error –241, "Hardware missing" occurs
If the command is used when an E9320 sensor is connected and set to
AVERage mode rather than NORMal mode, the error –221, "Settings
Conflict" occurs.
This command queries the current
duration of the trace.
N1911A/1912A P-Series Power Meters Programming Guide