Agilent Technologies N1911A Programming Manual page 7

N1911A/1912A P-Series Power Meters Programming Guide
SYSTem Subsystem
12
subsystem is used to return error numbers and messages from the power
meter, preset the power meter, set the remote address, and query the SCPI
version.
TRACe Subsystem
13
subsystem is used to configure and read back the measured power trace.
TRIGger Subsystem
14
subsystem is used to synchronize device actions with events.
UNIT Subsystem
15
subsystem is used to set the power meter measurement units to Watts
and % (linear), or dBm and dB (logarithmic).
SERVice Subsystem
16
subsystem is used to obtain and set information useful for servicing the
power meter.
IEEE 488.2 Command Reference
17
the IEEE488.2 Common Commands that the power meter supports.
Calibration Factor Block Layout
A
the calibration factor block layout for E4410 Series, E9300 Series, E9320
Series and N8480 Series sensors (excluding Option CFT).
Chapter 12 explains how the SYSTem command
Chapter 13 explains how the TRACe command
Chapter 14 explains how the TRIGger command
Chapter 15 explains how the UNIT command
Chapter 16 explains how the SERVice command
Chapter 17 contains information about
Appendix A contains information on
vii