Agilent Technologies N1911A Programming Manual page 398

10 SENSe Subsystem
Example
SENS:AVER:SDET OFF
Reset Condition
On reset, step detection is enabled.
Query
[SENSe[1]]|SENSe2:AVERage:SDETect?
The query enters a 1 or 0 into the output buffer indicating the status of
step detection.
• 1 is returned when step detection is enabled
• 0 is returned when step detection is disabled
Query Example
SENS:AVER:SDET?
370
This command disables step detection.
This command queries whether step
detection is on or off.
N1911A/1912A P-Series Power Meters Programming Guide