1
Power Meter Remote Operation
•
•
The character_data values for the IP address, Subnet Mask, and Default
Gateway can range between 0.0.0.0 and 255.255.255.255.
If you configure an invalid IP Address or an IP address that is used by another device or
N O T E
host, an error message is generated. This error can be read by using the SYSTem:ERRor?
command.
The LAN setting values are stored in non- volatile memory and are not
part of the save- recall function.
USB Configuration
The USB interface requires no front panel or remote configuration.
The USB address cannot be changed - it is set at the factory and is
unique for each power meter.
For further information about the USB configuration refer to the P-Series Power Meters
N O T E
Installation Guide.
Before connecting the USB cable, make sure that I/O software is installed on your
N O T E
computer.
For more information about Agilent IO Libraries software refer to the Connectivity Guide.
N O T E
If you have installed other I/O Software, refer to documentation that accompanies the
software
8
Hostname - SYSTem:COMMunicate:LAN:HNAMe
Restart Network - SYSTem:COMMunicate:LAN:RESTart
.
N1911A/1912A P-Series Power Meters Programming Guide