[SENSe[1]]|SENSe2:V2P ATYPe|DTYPe
This command is used to select the type of linearity correction that is
applied to the channel sensors being used. For most 8480 Series sensors,
the correct (A type or D type) linearity correction table is automatically
selected. However, for the V8486A and W8486A sensors, D type (diode)
correction is selected and the automatic selection must be overridden.
This command is only applicable for V8486A and W8486A sensors.
N O T E
Syntax
Example
SENS2:V2P DTYP
Reset Condition
On reset, the linearity correction is set for A type.
N1911A/1912A P-Series Power Meters Programming Guide
:
SENS
1
SENS2
Space
V2P
This command selects the D type linearity
correction to be applied to Channel B.
SENSe Subsystem
ATYP
DTYP
?
451
10