Agilent Technologies N1911A Programming Manual page 177

Example
MEAS2:POW:AC?
-70DBM,1,(@1)
N1911A/1912A P-Series Power Meters Programming Guide
Item Description/Default
source list The channel which the command is
implemented on.
If unspecified the current window setup is
used. However, on the N1912A, if the window
shows a ratio or difference measurement, the
upper window defaults to Channel A and the
lower window to Channel B.
1
The mnemonic DEF means DEFault. This is not equivalent to the DEFault parameter used in the
command sub-systems. The parameters must be entered in the specified order. If parameters are
omitted, they default from the right. The parameter DEFault is used as a place holder. Specifying
DEF leaves the parameter value unchanged.
2
When the measurement result is linear this parameter represents the number of significant
digits. When the measurement result is logarithmic 1 to 4 represents of 1, 0.1, 0.01 and 0.001
respectively.
MEASurement Commands
This command queries the lower
window/upper measurement of
Channel A, using an expected power level
of - 70 dBm and a resolution setting of 1.
2
Range of Values
(@1)
(@2) (N1912A only)
149