Initiate[:Immediate]:Sequence[1]|2 - Agilent Technologies N1911A Programming Manual

INITiate[:IMMediate]:SEQuence[1]|2

This command sets the power meter in the wait for trigger state. When a
trigger is received, the measurement is taken and the result placed in the
power meter memory. If TRIGger:SOURce is set to IMMediate the
measurement begins as soon as INITiate:IMMediate is executed.
Use FETCh? to transfer a measurement from memory to the output buffer.
Refer to
This command performs the same function as INITiate[1]|2:[IMMediate].
N O T E
Syntax
Example
INIT:IMM:SEQ1
Error Messages
If the power meter is not in the "idle" state or INITiate:CONTinuous is
ON, error –213, "INIT ignored" occurs.
N1911A/1912A P-Series Power Meters Programming Guide
"FETCh[1]|2|3|4 Queries"
INIT :IMM
on page 110 for further information.
:SEQ 1
2
This command places Channel A in
the wait for trigger state.
TRIGger Subsystem
657
14