Sense Subsystem - Agilent Technologies ESA-E Series Programmer's Manual

Language Reference

SENSe Subsystem

SENSe Subsystem
Sets the instrument state parameters so that you can measure the
input signal.
SENSe subsystem commands used for measurements in the
MEASURE
and menus may only be used to set parameters of a specific
Meas Setup
measurement when the measurement is active. Otherwise, an error will
occur. You must first select the appropriate measurement using the
:CONFigure:<measurement> command. If a :SENSe command is
used to change a parameter during a measurement (while not in its idle
state), the measurement will be restarted.
Chapter 5 5-79