Show Crypto Ipsec Sa Ipv6 - Dell Force10 Z9000 Reference Manual

show crypto ipsec sa ipv6

Display the IPsec security associations (SAs) used on OSPFv3 interfaces.
E-Series TeraScale, Z-Series, S4810
Syntax show crypto ipsec sa ipv6 [interface interface]
Parameters
interface
interface
Defaults No default behavior or values.
Command Modes
EXEC
EXEC Privilege
Command History
Version 9.1.(0.0)
Version 8.4.2.0
Usage
The show crypto ipsec sa ipv6 command output displays security associations set up for
Information
OSPFv3 links in IPsec authentication and encryption policies on the router.
Related
show crypto
Commands
ipsec policy
Example
FTOS#show crypto ipsec policy
FTOS#show crypto ipsec sa ipv6
Interface: TenGigabitEthernet 0/0
Link Local address: fe80::201:e8ff:fe40:4d10
IPSecv6 policy name: OSPFv3-1-500
inbound ah sas
(OPTIONAL) Displays information about the SAs used on a specified
OSPFv3 interface, where
•
•
•
•
•
Introduced on the S4810 and Z9000.
Introduced on the E-Series TeraScale.
Display the configuration of IPsec authentication and encryption
policies.
spi : 500 (0x1f4)
transform : ah-md5-hmac
in use settings : {Transport, }
replay detection support : N
STATUS : ACTIVE
interface is one of the following values:
For a 1-Gigabit Ethernet interface, enter GigabitEthernet
port .
For a Port Channel interface, enter port-channel
Valid port-channel numbers (on an E-Series TeraScale): 1 to
255.
For a 10-Gigabit Ethernet interface, enter TenGigabitEthernet
slot / port .
For a 40–Gigabit Ethernet interface, enter fortyGigE
For a VLAN interface, enter vlan
4094.
slot /
number .
slot / port .
vlan-id . Valid VLAN IDs: 1 to
1123