Dell Force10 Z9000 Reference Manual page 1092

Usage The following describes the show ip ospf process-id interface command
Information shown in the Example below.
Item
GigabitEthernet...
Internet Address...
Process ID...
Transmit Delay...
Designated Router...
Backup
Designated...
Timer intervals...
Hello due...
Neighbor Count...
Example
FTOS>show ip ospf int
GigabitEthernet 13/17 is up, line protocol is up
BROADCAST, Cost: 1
192.168.1.2
address 192.168.1.1
Retransmit 5
Router)
GigabitEthernet 13/23 is up, line protocol is up
BROADCAST, Cost: 1
192.168.0.4
address 192.168.0.2
Retransmit 5
1092
Description
This line identifies the interface type slot/port and the status of the
OSPF protocol on that interface.
This line displays the IP address, network mask and area assigned to
this interface.
This line displays the OSPF Process ID, Router ID, Network type and
cost metric for this interface.
This line displays the interface's settings for Transmit Delay, State,
and Priority. In the State setting, BDR is Backup Designated Router.
This line displays the ID of the Designated Router and its interface
address.
This line displays the ID of the Backup Designated Router and its
interface address.
This line displays the interface's timer settings for Hello interval,
Dead interval, Transmit Delay (Wait), and Retransmit Interval.
This line displays the amount time untill the next Hello packet is sent
out this interface.
This line displays the number of neighbors and adjacent neighbors.
Listed below this line are the details about each adjacent neighbor.
Internet Address 192.168.1.2/30, Area 0.0.0.1
Process ID 1, Router ID 192.168.253.2, Network Type
Transmit Delay is 1 sec, State DR, Priority 1
Designated Router (ID) 192.168.253.2, Interface address
Backup Designated Router (ID) 192.168.253.1, Interface
Timer intervals configured, Hello 10, Dead 40, Wait 40,
Hello due in 00:00:02
Neighbor Count is 1, Adjacent neighbor count is 1
Adjacent with neighbor 192.168.253.1 (Backup Designated
Internet Address 192.168.0.1/24, Area 0.0.0.1
Process ID 1, Router ID 192.168.253.2, Network Type
Transmit Delay is 1 sec, State DROTHER, Priority 1
Designated Router (ID) 192.168.253.5, Interface address
Backup Designated Router (ID) 192.168.253.3, Interface
Timer intervals configured, Hello 10, Dead 40, Wait 40,