Dell Force10 Z9000 Reference Manual page 1127

Parameters
interface
Defaults No default behavior or values.
Command Modes
EXEC
Command History
Version 9.1.(0.0)
Version 7.8.1.0
Version 7.4.1.0
Example
show ipv6 ospf interface command
FTOS#show ipv6 ospf interface gigabitethernet 1/0
GigabitEthernet 1/0 is up, line protocol is up
67420217
Retransmit 5
FTOS#
(OPTIONAL) Enter one of the following keywords and slot/port or
number information:
•
•
•
•
•
•
Added support for OSPFv3 on the S4810 and Z9000.
Added support for the C-Series.
Introduced on the E-Series.
Link Local Address fe80::201:e8ff:fe17:5bbd, Interface ID
Area 0, Process ID 1, Instance ID 0, Router ID 11.1.1.1
NetworkType BROADCAST, Cost: 1, Passive: No
Transmit Delay is 100 sec, State DR, Priority 1
Designated router on this network is 11.1.1.1 (local)
No backup designated router on this network
Timer intervals configured, Hello 10, Dead 40, Wait 1,
For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet and the slot/port information.
For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet and the slot/port information.
For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE and the slot/port information.
For a Port Channel interface, enter the keyword port-channel
and a number:
– C-Series, Z-Series, and S4810 Range: 1 to 128
– E-Series Range: 1 to 255 for TeraScale and 1 to 512
for ExaScale.
For a SONET interface, enter the keyword sonet and the slot/
port information.
For a VLAN, enter the keyword vlan and a number from 1 to
4094.
1127