Dell Force10 Z9000 Reference Manual page 1096

Version 7.4.1.0
Usage The following describes the show ip ospf statistics process-id global
Information
command shown in the Example below.
Row Heading
Total
Error
Hello
DDiscr
LSReq
LSUpd
LSAck
TxQ-Len
RxQ-Len
Tx-Mark
Rx-Mark
Hello-Q
LSR-Q
Other-Q
The following describes the error definitions for the show ip ospf statistics
process-id global command.
Error Type
Intf_Down
Non-Dr
Self-Org
Wrong_Len
Invld-Nbr
Nbr-State
1096
Introduced on the E-Series.
Description
Displays the total number of packets received/transmitted by the
OSPF process.
Displays the error count while receiving and transmitting packets by
the OSPF process.
Number of OSPF Hello packets.
Number of database description packets.
Number of link state request packets.
Number of link state update packets.
Number of link state acknowledgement packets.
The transmission queue length.
The reception queue length.
The highest number mark in the transmission queue.
The highest number mark in the reception queue.
The queue, for transmission or reception, for the hello packets.
The queue, for transmission or reception, for the link state request
packets.
The queue, for transmission or reception, for the link state
acknowledgement, database description, and update packets.
Description
Received packets on an interface that is either down or OSPF is not
enabled.
Received packets with a destination address of ALL_DRS even
though SELF is not a designated router.
Receive the self originated packet.
The received packet length is different to what was indicated in the
OSPF header.
LSA, LSR, LSU, and DDB are received from a peer which is not a
neighbor peer.
LSA, LSR, and LSU are received from a neighbor with stats less than
the loading state.