Show Ip Ospf Asbr; Show Ip Ospf Database - Dell Force10 Z9000 Reference Manual

Ftos command line reference guide for the z9000 system ftos 9.1.(0.0)

Hide thumbs Also See for Force10 Z9000:

Table of Contents

show ip ospf asbr

Display all autonomous system boundary router (ASBR) routers visible to OSPF.

C-Series, E-Series, S-Series, Z-Series, S4810

show ip ospf process-id asbr

Command Modes

Command History

Version 8.3.11.1

Version 8.3.7.0

Version 7.8.1.0

Version 7.6.1.0

Version 7.5.1.0

Use this command to isolate problems with external routes. In OSPF, external routes are

calculated by adding the LSA cost to the cost of reaching the ASBR router. If an external route

does not have the correct cost, use this command to determine if the path to the originating

router is correct. The display output is not sorted in any order.

You can determine if an ASBR is in a directly connected area (or not) by the flags. For ASBRs in

a directly connected area, E flags are set. In the Example below, router 1.1.1.1 is in a directly

connected area since the Flag is E/-/-/. For remote ASBRs, the E flag is clear (-/-/-/).

FTOS#show ip ospf 1asbr

Display all LSA information. If you do not enable OSPF on the switch, no output is generated.

C-Series, E-Series, S-Series, Z-Series, S4810

show ip ospf process-id database [database-summary]

Enter the OSPF Process ID to show a specific process. If no Process

ID is entered, command applies only to the first OSPF process.

EXEC Privilege

Introduced on the Z9000.

Introduced on the S4810.

Added support of Multi-Process OSPF.

Added the process-id option, in support of Multi-Process OSPF.

Introduced on the S-Series.

Introduced on the C-Series and E-Series.

NOTE: ASBRs that are not in directly connected areas are also displayed.

Cost Nexthop

Interface Area