Ipv6 Ospf Authentication - Dell Force10 Z9000 Reference Manual

area
Defaults No default values or behavior.
Command Modes INTERFACE
Command History
Version 9.1.(0.0)
Version 7.4.1.0

ipv6 ospf authentication

Configure an IPsec authentication policy for OSPFv3 packets on an IPv6 interface.
E-Series TeraScale, Z-Series, S4810
Syntax ipv6 ospf authentication {null | ipsec spi number {MD5 | SHA1}
[key-encryption-type] key}}
Parameters
null
ipsec spi number
MD5 | SHA1
key-encryption-
type
key
Defaults Not configured.
Command Modes INTERFACE
Command History
Version 9.1.(0.0)
Version 8.4.2.0
Usage
Before you enable IPsec authentication on an OSPFv3 interface, you must first enable IPv6
Information
unicast routing globally, configure an IPv6 address and enable OSPFv3 on the interface, and
assign the interface to an area.
An SPI value must be unique to one IPsec security policy (authentication or encryption) on the
router. You must configure the same authentication policy (same SPI and key) on each OSPFv3
interface in a link.
1112
area-id
Specify the OSPF area. Range: 0 to 65535
Introduced on the S4810 and Z9000.
Introduced on the E-Series and C-Series.
Causes an authentication policy configured for the area to not be
inherited on the interface.
Security Policy index (SPI) value that identifies an IPsec security
policy. Range: 256 to 4294967295.
Authentication type: Message Digest 5 (MD5) or Secure Hash
Algorithm 1 (SHA-1).
(OPTIONAL) Specifies if the key is encrypted.
Valid values: 0 (key is not encrypted) or 7 (key is encrypted).
Text string used in authentication.
For MD5 authentication, the key must be 32 hex digits (non-
encrypted) or 64 hex digits (encrypted).
For SHA-1 authentication, the key must be 40 hex digits (non-
encrypted) or 80 hex digits (encrypted).
Introduced on S4810 and Z9000.
Introduced on the E-Series.