Alcatel OmniAccess Wireless System 2.1 Product Manual page 528

Table -
Tx Power Level Assignment (Continued)
Parameter
Power Update Contribution
Power Assignment Leader
Last Power Level Assignment
Table -
Profile Thresholds
Parameter
Interference (0 to 100%)
Clients (1 to 75)
Noise (-127 to 0 dBm)
Coverage (3 to 50 dBm)
Utilization (0 to 100%)
Coverage Exception Level
(0 to 100%)
Data Rate (1 to 1000 Kbps)
Client Min Exception Level
(1 to 75)
Table -
Monitor Intervals
Parameter
Noise Measurement
Load Measurement
Signal Measurement
Coverage Measurement
Intervals from 60 to 3600 seconds.
Note:
11/5/04
90-100831-300 Rev 2Alcatel OmniAccess Wireless Access Point Quick Installation Guide 79
This read-only field displays the factors used for changing power
level assignments. The factors are:
• L (Load)
• S (Signal)
• N (Noise)
• I (Interference)
For each factor listed, the corresponding measurement is used in the
power assignment algorithm.
MAC address of the power level assignment leader.
The elapsed time since the last transmit power assignment in
seconds.
Foreign 802.11a interference threshold between 0 and 100 percent.
Client threshold between 1 and 75 clients.
Foreign noise threshold between -127 and 0 dBm.
802.11a coverage threshold between 3 and 50 dB.
802.11a RF utilization threshold between 0 and 100 percent.
Coverage exception level between 0 and 100 percent.
802.11a throughput threshold between 1 Kbps and 1000 Kbps.
Client minimum exception level.
The interval (in seconds) for noise and interference measurements at
each OmniAccess AP 1200 or 1250. Default is 300 seconds.
The interval (in seconds) for load measurements at each OmniAccess
AP 1200 or 1250. Default is 300 seconds.
The interval (in seconds) for strength measurements at each
OmniAccess AP 1200 or 1250. Default is 300 seconds.
The interval (in seconds) for coverage measurements at each
OmniAccess AP 1200 or 1250. Default is 300 seconds.
802.11a Global Parameters > Auto RF
Description
Description
Description