Config Prompt; Config Qos Queue_Length - Alcatel OmniAccess Wireless System 2.1 Product Manual

you are using Third-Party access points, refer to your user documentation to determine compatibility.
Enabling POE to non-compatible APs can result in severe equipment damage including fire!
>config port power [<port number>/all] [enable/disable]
Syntax
Default
Examples
Related Commands

config prompt

config prompt
To change the CLI system prompt, use the config prompt command.
This command can be used any time the CLI interface is active.
>config prompt <system prompt>
Because the system prompt is a user-defined variable, it is omitted from the rest of this documentation.
Syntax
Defaults
Examples
Related Commands

config qos queue_length

To configure the qos parameter, use the config qos command.
>config qos queue_length [bronze/silver/gold] <length>
Syntax
Defaults
Examples
Related Commands
11/5/04
90-100831-300 Rev 2Alcatel OmniAccess Wireless Access Point Quick Installation Guide 129
config
port
power
[<port number>/all]
[enable/disable]
Enabled
To disable POE on port 8:
>config port power 8 disable
To enable POE on all ports:
>config port power all enable
show port
config
prompt
<system prompt>
The system prompt is configured using the startup wizard.
config prompt "Type here"
(old CLI prompt >
Type here>
(none)
config qos queue_length
config qos
queue_length
bronze/silver/gold
<length>
N/A
>config qos queue_length gold 12
show qos queue_length all
Configure parameters.
Port parameters
POE mode
Individual port number or all ports
Port state
Configure parameters.
CLI system prompt, up to 31 alphanumeric
characters.
New CLI system prompt, in double quotes.
Command action.
Configure qos queue length.
Level of quality of service.
Queue length.
config prompt