Configure Radio Template > Apply To Radios; Configure Template > <Template> > Apply To Switches - Alcatel OmniAccess Wireless System 2.1 Product Manual

Table -
Access Point Parameters
Column
Checkboxes
MAC Address
Name
Switch IP Address
Map Location
Command Buttons
•
OK: Click to apply the selected parameters to the selected OmniAccess AP Access Points and
display the Configure AP Template Results > Apply to APs
•
Cancel
Configure Radio Template > Apply to Radios
Use CONFIGURE/Templates, from the left sidebar menu select Radio Templates, select parameters
to apply to one or more OmniAccess Radios, and then click Apply to Radios to access this page.
This page allows you to edit one or more OmniAccess Radios with a template of OmniAccess Radio
information entered on the
Table -
OmniAccess Radio Parameters
Column
Checkboxes
MAC Address
Protocol
Name
Switch IP Address
Command Buttons
•
OK: Click to apply the selected parameters to the selected OmniAccess Radios and display the
Configure Radio Template Results > Apply to Radios
•
Cancel
Configure Template > <template> > Apply to Switches
Use CONFIGURE/Templates and from the left sidebar menu, under Security select Local Net
Users, click a list item under User Name, and click Apply to Switches to access this page.
11/5/04
90-100831-300 Rev 2Alcatel OmniAccess Wireless Access Point Quick Installation Guide 226
Checkmark to select one or more OmniAccess AP Access Points to have
the AP Template parameters applied.
OmniAccess AP 1200 or 1250 MAC Address (read only).
OmniAccess AP 1200 or 1250 Name (read only).
Alcatel OmniAccess Switch or Appliance IP Address (read only).
OmniAccess AP 1200 or 1250 location, if assigned to a map location (read
only).
Configure Radio Template
Checkmark to select one or more OmniAccess Radios to have the
OmniAccess Radio Template parameters applied.
OmniAccess Radio MAC Address (read only).
802.11a or 802.11b/g (read only).
OmniAccess Radio Name (read only).
Alcatel OmniAccess Switch or Appliance IP Address (read only).
Configure Radio Template > Apply to Radios
Options
page.
Configure Radio Template > Apply to Radios
page.
Options
page.
Configure Template > <template> > Apply to Switches