Step 4. Omniaccess Ap 1200 Or 1250 Placement Guidelines; Collecting Maps Or Building Floor Plans; Noting Any Deployment Constraints; Access Point Placement Guidelines - Alcatel OmniAccess Wireless System 2.1 Product Manual

Step 4. OmniAccess AP 1200 or 1250 Placement Guidelines

This step describes where and how OmniAccess AP Access Points should be placed. You must know
certain information to select OmniAccess AP 1200 or 1250 locations:
•

Collecting Maps or Building Floor Plans

•

Noting Any Deployment Constraints

•

Access Point Placement Guidelines

•
OmniAccess AP 1200 or 1250 Placement
Collecting Maps or Building Floor Plans
Collect maps or building plans of the areas to be covered, with a feet or meters scale included.
Figure -
Typical Floor Plan -- Open Auditorium with Cubicles
Noting Any Deployment Constraints
•
If the OmniAccess AP Access Points are to use existing wiring, note these locations on the map.
•
If there are locations where OmniAccess AP Access Points cannot be placed, note these
locations on the map.
Access Point Placement Guidelines
•
Position the OmniAccess AP Access Points above obstructions.
11/5/04 Step 4. OmniAccess AP 1200 or 1250 Placement Guidelines
90-100831-300 Rev 2Alcatel OmniAccess Wireless Access Point Quick Installation Guide 22
Collecting Maps or Building Floor Plans
Noting Any Deployment Constraints
Access Point Placement Guidelines
Step 4. OmniAccess AP 1200 or 1250 Placement Guidelines