Wlan Policy Configuration - Alcatel OmniAccess Wireless System 2.1 Product Manual

2.
The DNS Host Name box contains a space for a Web Auth ID Certificate DNS Host Name. If the
Alcatel OmniAccess Switch or Appliance will use an externally-generated Web Auth ID Certifi-
cate that includes a DNS Host Name, enter the DNS Host Name here.
3.
Click Next to have the Alcatel OmniAccess Switch or Appliance save your inputs and display the

WLAN Policy Configuration

WLAN Policy Configuration
Refer to the WLANs > Edit
1.
The WLAN SSID box contains the current WLAN 1 SSID. If desired, enter a different SSID.
2.
The Radio Policy box contains the default bands controlled by the WLAN 1 policy. If desired,
enter a different WLAN 1 policy: 802.11a only, 802.11g only, 802.11b/g only, 802.11a/g only,
or All.
3.
The Admin Status box contains the default administrative status (unchecked, or disabled). If
desired, enable the WLAN 1 policy by checking the Admin Status box.
4.
The Session Timeout box contains the default 802.11 session timeout (0, or no timeout). If
desired, enter a different 802.11 session timeout in minutes.
5.
The Quality of Service (QoS) box contains the default QoS status (Bronze, or lowest QoS). If
desired, enter a different QoS: Gold = highest, Silver, or leave as Bronze = lowest.
6.
The Allow AAA Override box contains the default AAA Override status (unchecked, or disabled).
If desired, enable AAA Override by checking the AAA Override box.
7.
The Blacklist Exclusion List Timeout box contains the default client Exclusion List (blacklist)
timeout status (checked, or enabled). If desired, disable Exclusion List (Blacklist) Timeout by
unchecking the Blacklist Timeout box.
8.
When Blacklist (Exclusion List) Timeout is enabled, enter the number of seconds a client is
added to the Exclusion List (blacklisted) upon failing to authenticate three consecutive times.
9.
The DHCP Server Override box contains the current status (unchecked, or disabled). If desired,
enable DHCP Server Override by checking the Override box.
10.
The DHCP Addr. Assignment Required box contains the current status (unchecked, or not
required). If desired, enable DHCP Address Assignment Required parameter by checking the
Required box.
11.
The Interface Name box contains the current WLAN 1 Interface (management). Leave this
setting unchanged.
12.
The Layer 2 Security box contains the default Layer 2 Security setting (802.1X). If desired,
select a different Layer 2 Security setting: None, WPA, 802.1X, Static WEP, Cranite, or
Fortress. Refer to the
parameters that can be set for Layer 2 Security.
13.
The Layer 3 Security box contains the default Layer 3 Security setting (None). If desired, select
a different Layer 3 Security setting: None, IPSec, or VPN Pass Through. Refer to the
Edit page for a description of these parameters, and the related parameters that can be set for
Layer 3 Security.
14.
Click Next to have the Alcatel OmniAccess Switch or Appliance save your inputs and display the
RADIUS Server Configuration
11/5/04
90-100831-300 Rev 2Alcatel OmniAccess Wireless Access Point Quick Installation Guide 128
page, in which you will configure the WLAN 1 parameters.
WLAN Policy Configuration
page for a description of these parameters.
WLANs > Edit page for a description of these parameters, and the related
page, in which you will configure the RADIUS server parameters.
WLAN Policy Configuration
WLANs >