Table of Contents
Advertisement
About the Command Line Interface
Command Line Interface
The Alcatel OmniAccess Wireless System Command Line Interface (CLI) is built into the Alcatel Omni-
Access WLAN Switches and Appliances, and is one of the Alcatel OmniAccess Operating System user
interfaces described in
About the Alcatel OmniAccess Wireless
System. The CLI allows operators to use
a VT-100 emulator to locally or remotely configure, monitor and control individual Alcatel OmniAccess
Switches and Appliances, and to access extensive debugging capabilities.
Because the CLI works with one Alcatel OmniAccess Switch or Appliance at a time, the Command Line
Interface is especially useful when you wish to configure or monitor a single Alcatel OmniAccess Switch
or Appliance.
The Alcatel OmniAccess Switch or Appliance and its associated OmniAccess AP Access Points can be
configured and monitored using the Command Line Interface (CLI), which consists of a simple
text-based, tree-structured interface that allows up to five users with Telnet-capable terminal
emulators to simultaneously configure and monitor all aspects of the Alcatel OmniAccess Switch or
Appliance and associated OmniAccess AP Access Points.
Refer to
Using the Alcatel OmniAccess Wireless System CLI
and the
Alcatel OmniAccess Wireless
System CLI Reference
for more information.
11/5/04
Command Line Interface
90-100831-300 Rev 2Alcatel OmniAccess Wireless Access Point Quick Installation Guide 65
Advertisement
Chapters
Table of Contents
Troubleshooting
Need help?
Do you have a question about the OmniAccess Wireless System 2.1 and is the answer not in the manual?