config snmp v3user create
To add a version 3 SNMP user, use the config snmp v3user create command.
>config snmp v3user <username> [rw/ro] [none/hmacmd5/hmacsha] [none/des]
<authkey> <encrypkey>
Syntax
Defaults
Examples
Related Commands
config snmp v3user delete
To delete a version 3 SNMP user, use the config snmp v3user delete command.
>config snmp v3user delete <username>
Syntax
Defaults
Examples
Related Commands
config snmp version
To enable or disable selected SNMP versions, use the config snmp version command.
>config snmp version <v1/v2/v3> <enable/disable>
Syntax
11/5/04
90-100831-300 Rev 2Alcatel OmniAccess Wireless Access Point Quick Installation Guide 141
config snmp v3user create
config
snmp
v3user
<username>
[rw/ro]
[none/hmacmd5/hmacsha]Authentication protocol.
[none/des]
<authkey>
<encrypkey>
SNMP v3 User Name
-------------------- ----------- -------------- ----------
default
>config snmp v3user test ro 3
to add an SNMP username test with read-only privileges and no encryption or
authentication.
show snmp v3user
config snmp v3user delete
config
snmp
v3user
delete
<username>
SNMP v3 User Name
-------------------- ----------- -------------- ----------
default
>config snmp v3user delete test
This will remove an SNMP user named test.
show snmp v3user
config snmp version
config
snmp
version
<v1/v2/v3>
<enable/disable>
Configure parameters.
SNMP parameters.
Version 3 SNMP.
New user name.
Read/write or read/only user privileges.
Encryption protocol.
Authentication key, if enabled.
Encryption key, if enabled.
AccessMode
Authentication Encryption
Read/Write
HMAC-MD5
Configure parameters.
SNMP parameters.
Version 3 SNMP.
Remove user.
Username to delete.
AccessMode
Authentication Encryption
Read/Write
HMAC-MD5
Configure parameters.
SNMP parameters.
Duration of CLI sessions.
SNMP version to enable or disable
Enable or disable specified version
config snmp v3user create
CBC-DES
CBC-DES
Need help?
Do you have a question about the OmniAccess Wireless System 2.1 and is the answer not in the manual?