Configure Manually Disabled Clients - Alcatel OmniAccess Wireless System 2.1 Product Manual

Configure Manually Disabled Clients

Use CONFIGURE/Switches, click an item under IP Address, on the left sidebar menu select Security/
Manually Disabled Clients to access this page.
Note that the Standalone WPS Alcatel OmniAccess Wireless System described in About the Alcatel
OmniAccess Wireless System in the Alcatel OmniAccess Wireless Product Guide does not support voice
or data clients.
This page allows you to view Excluded (blacklisted) client information.
Clients who fail to authenticate three times when attempting to associate are automatically blocked, or
Excluded, from further association attempts for an operator-defined timeout. After the Excluded
timeout, the client is allowed to retry authentication until it associates or fails authentication and is
Excluded again.
Table -
Disabled Clients
Parameter
Checkbox
MAC Address
Description
Select a command
•
Add Manually Disabled Client: Select this command and click GO. Refer to
> Manually Disabled Clients > Add From
•
Delete Manually Disabled Clients: Select this command and click GO.
Configure <IPaddr> > Manually Disabled Clients
Use MONITOR/Clients, click Manually Disabled Clients, then click an item under MAC Address to
access this page.
Note that the Standalone WPS Alcatel OmniAccess Wireless System described in About the Alcatel
OmniAccess Wireless System in the Alcatel OmniAccess Wireless Product Guide does not support data
or voice clients.
This page allows you to edit a manually disabled client template description.
Table -
Client Properties
Parameter
MAC Address
Description
Command Buttons
•
Save
•
Audit
11/5/04
90-100831-300 Rev 2Alcatel OmniAccess Wireless Access Point Quick Installation Guide 142
Configure Manually Disabled Clients
Select to delete Manually Disabled Clients.
Disabled Client MAC addresses. Click a list item to edit the disabled client
description. Refer to Configure <IPaddr> > Manually Disabled
Optional description of disabled client.
Template.
Client MAC address (read only).
Optional user-defined description.
Configure Manually Disabled Clients
Description
Configure <IPaddr> > Manually Disabled Clients
Description
Clients.
Configure <IPaddr>