Config Load-Balancing; Config Loginsession Close; Config Macfilter Commands - Alcatel OmniAccess Wireless System 2.1 Product Manual

Defaults
Examples
Related Commands

config load-balancing

To change the state of the load-balancing feature, use the config load-balancing command.
>config load-balancing [enable/disable]
Syntax
Defaults
Examples
Related Command

config loginsession close

To close active telnet sessions, use the config loginsession close command. Use this command to
terminate an individual or all active telnet sessions with the Alcatel OmniAccess Switch or Appliance. If
you are using a telnet session for your CLI interface and terminate your session or all sessions, you will
need to reconnect and log back into the Alcatel OmniAccess Switch or Appliance.
>config loginsession close [<session id>/ all]
Syntax
Defaults
Examples
Related Commands

CONFIG MACFILTER COMMANDS

Use the following config macfilter commands.
Note that the Standalone WPS Alcatel OmniAccess Wireless System described in About the Alcatel
OmniAccess Wireless System in the Alcatel OmniAccess Wireless Product Guide does not support
WLANs or MAC filters.
•
config macfilter add
•
config macfilter delete
11/5/04
90-100831-300 Rev 2Alcatel OmniAccess Wireless Access Point Quick Installation Guide 109
management
vlan-intf-name
<vlan>
N/A
>config interface vlan management 01
Request failed - Active WLAN using interface. Disable WLAN first.
show interface
config load-balancing
config
load-balancing
[enable/disable]
Enabled
>config load-balancing enable
show load-balancing
config loginsession close
config
loginsession
close
<session id>
all
(none)
>config loginsession close all
show loginsession
config macfilter
The management interface.
VLAN identifier name.
VLAN id.
Configure parameters.
Aggressive load-balancing
Enable or disable the feature
Configure parameters.
Telnet sessions.
Terminate session.
Terminate a specific telnet session.
Terminate all telnet sessions.
config load-balancing