Configure <Ipaddr> > Trap Receiver > Add From Template; Configure/Access Points Menu Bar Selection - Alcatel OmniAccess Wireless System 2.1 Product Manual

•
Select a template to create from: NTP Server pulldown.
Command Buttons
•
Create
•
Cancel
To create a New Template for 'NTP Servers'
Configure NTP Servers > New Template
Table -
NTP General
Parameter
Template Name
Server Address
No. of Switches Applied
To
Command Buttons
•
Save
•
Cancel
Configure <IPaddr> > Trap Receiver > Add From Template
Use CONFIGURE/Switches, click an IP address under the IP Address column, on the left sidebar
menu, select Management and click Trap Receivers, from the Select a command pulldown, select
Add Receiver to access this page.
•
Select a template to create from IP Address: IP Address pulldown.
Command Buttons
•
Create
•
Cancel
To create a New Template for 'Trap Receiver' click here to get redirected to template creation page.
•
Template Name: User-defined Trap Receiver name.
•
No. of Switches Applied To (read only): Number of Alcatel OmniAccess Switches and Appliances
to which this information is applied.
•
IP Address: Trap Receiver IP Address.
•
Admin Status: Whether the Trap Receiver is enabled or disabled.

CONFIGURE/ACCESS POINTS MENU BAR SELECTION

This menu bar selection provides access to the OmniAccess AP 1200 or 1250 summary details. Use the
selector area to access and configure the respective access points details. Making this selection from
the menu bar displays
11/5/04 Configure <IPaddr> > Trap Receiver > Add From Template
90-100831-300 Rev 2Alcatel OmniAccess Wireless Access Point Quick Installation Guide 133
click here
.
Enter the new NTP Template name.
Enter the NTP server IP address.
Number of Alcatel OmniAccess Switches and Appliances to which this
template is applied (read only).
Configure All Access Points.
to get redirected to template creation page,
Description
Configure <IPaddr> > Trap Receiver > Add From Template
CONFIGURE/ACCESS POINTS MENU BAR SELECTION