Transferring Files To And From An Alcatel Omniaccess Switch Or Appliance - Alcatel OmniAccess Wireless System 2.1 Product Manual

System (network) port. To display and configure the Service port parameters, use the following
commands:
show serviceport
>
config serviceport params
>
config serviceport protocol
>
OmniVista AirView Software
•
The Alcatel OmniAccess Operating System OmniVista AirView Software function automatically
recognizes OmniAccess AP Access Points as they appear in the air space, and when they are
part of the same
their respective frequency bands.
Typically, you will not need to manually configure anything after enabling and/or disabling the
802.11a and 802.11b/g networks as described in
you may want to fine-tune the network operation using the config 802.11a, config
802.11b, config advanced 802.11a, config advanced 802.11b, config cell, and
config load balancing command sets.
Serial (CLI Console) Port
•
The Alcatel OmniAccess Switch or Appliance front-panel serial port is set for a 9600 baud rate
and a short timeout. If you would like to change either of these values, use the config serial
baudrate and config serial timeout commands to make your changes. Note that if you
enter config serial timeout 0, serial sessions never time out.
802.3x Flow Control
802.3x Flow Control
•
802.3x Flow Control is normally disabled on the Alcatel OmniAccess Switch and Appliance. If
you would like to change either of these settings, use the config switchconfig flowcontrol
command.
System Logging
System Logging
•
Alcatel OmniAccess Switches and Appliances are shipped with the syslog function disabled. Use
the show syslog command to view the current syslog status, and if required, use the config
syslog command to send an Alcatel OmniAccess Switch or Appliance log to a remote IP
Address or hostname.
You have configured the basic parameters for an Alcatel OmniAccess Wireless System. Continue with
Using the Alcatel OmniAccess Wireless System

Transferring Files To and From an Alcatel OmniAccess Switch or Appliance

Alcatel OmniAccess Switch or Appliance
Alcatel OmniAccess Switches and Appliances have built-in utilities for uploading and downloading
Alcatel OmniAccess Operating System software, certificate and configuration files. Refer to the
following for additional information.
CAUTION:
can be from 512 bits, which is relatively insecure, through thousands of bits, which is
very secure. When you are obtaining a new certificate from a Certificate Authority
(such as the Microsoft CA), MAKE SURE the RSA key embedded in the certificate is
AT LEAST 768 Bits.
•
Use the CLI transfer commands to perform these actions:
>transfer download datatype
>transfer download filename
11/5/04 Transferring Files To and From an Alcatel OmniAccess Switch or Appliance
90-100831-300 Rev 2Alcatel OmniAccess Wireless Access Point Quick Installation Guide 121
OmniVista AirView Software
Alcatel Mobility Groups, automatically configures them for optimal operation in
Serial (CLI Console) Port
Each certificate has a variable-length embedded RSA Key. The RSA key
Configuring System
CLI.
Parameters. However,
Transferring Files To and From an