Step 5: Performing Power On Self Test - Alcatel OmniAccess Wireless System 2.1 Product Manual

Step 5: Performing Power On Self Test

When you plug an Alcatel OmniAccess Switch or Appliance into an AC power source, the bootup script
initializes the system, verifies the hardware configuration, loads its microcode into memory, verifies its
Alcatel OmniAccess Operating System software load, and initializes itself with its stored configurations.
Do the following to perform POST and Alcatel OmniAccess Operating System software initialization:
Note:
Alcatel OmniAccess Switch or Appliance as described in
Using the CLI
•
Plug an AC power cord into the rear of the Alcatel OmniAccess Switch or Appliance, and connect
the other end to a grounded 95 to 260 VAC 50/60 Hz convenience outlet.
Note that Alcatel supplies a North-American standard power cord; if you need a different
country-specific cord, make sure the Alcatel OmniAccess Switch or Appliance end of the cord
conforms with the IEC 320 standard.
Note:
Appliance code, press the <ESC> key immediately after the Model and S/N line. This
will take you to the Bootloader Boot Options Menu.
•
Monitor the Alcatel OmniAccess Switch or Appliance bootup using the CLI Screen:
-
The Bootup script displays Alcatel OmniAccess Operating System software initialization
(code download and POST verification) and basic configuration as shown in the
following sample Bootup display:
oo
.d8888b. dP 88d888b. /
88' `88 88 88' `88 |
88. .88 88 88
`88888P8 dP dP
Press <ESC> now for additional boot options...
(If desired, press <ESC> now to display the Bootloader Boot Options Menu.)
Boot Options
Please choose an option from below:
1. Run active image (version 2.1.85.0)
2. Run backup image (version 2.0.112.0)
3. Manually perform system upgrade
4. Clear Configuration
Please enter your choice:
(Enter 1 to run the current Alcatel OmniAccess Switch or Appliance Code, enter 2 to run the
previous Alcatel OmniAccess Switch or Appliance Code, enter 4 to run the current Alcatel
11/5/04
90-100831-300 Rev 2Alcatel OmniAccess Wireless Access Point Quick Installation Guide 12
This procedure assumes that you have connected the CLI Console to the
Console.
If you wish to run a previous version of the Alcatel OmniAccess Switch or
_____
\ .d8888b. 88d888b. .d8888b. .d8888b. .d8888b.
== | Y8ooooo. 88'
| ___/ 88 88.
\_____| `88888P' 88Y888P' `88888P8 `88888P' `88888P'
Step 5: Performing Power On Self Test
`88 88' `88 88'
.88 88. .88 88.
88
dP
Model AS-4024 S/N: 01012403-10037905-01007
Step 5: Performing Power On Self Test
Step 4: Connecting and
`"` 88ooood8
... 88. ...