Snmp Trap Receiver > New; Snmp Trap Receiver > Edit; Snmp Trap Controls - Alcatel OmniAccess Wireless System 2.1 Product Manual

Command Buttons
•
New: Select to add a new trap receiver
•
Help: Request that the help page be displayed in a new browser window.
SNMP Trap Receiver > New
Use MANAGEMENT/SNMP Trap Recipients then New... to navigate to this page.
Use this page to add a server to receive SNMP traps from this Alcatel OmniAccess Switch or Appliance
as described in the following table.
Table -
SNMP Trap Receiver Details
Parameter
Trap Receiver Name
IP Address
Status
Command Buttons
•
Back: Return to the previous window.
•
Apply: Data is sent to the Alcatel OmniAccess Switch or Appliance and made to take effect, but
not preserved across a power cycle; these parameters are stored temporarily in volatile RAM.
•
Help: Request that the help page be displayed in a new browser window.
SNMP Trap Receiver > Edit
Use MANAGEMENT/SNMP Trap Recipients then Edit to navigate to this page.
You can use this page to Enable or Disable sending traps to a particular server. Only the Status field
can be modified.
Command Buttons
•
Back: Return to the previous window.
•
Apply: Data is sent to the Alcatel OmniAccess Switch or Appliance and made to take effect, but
not preserved across a power cycle; these parameters are stored temporarily in volatile RAM.
•
Help: Request that the help page be displayed in a new browser window.

SNMP Trap Controls

Use MANAGEMENT/SNMP Trap Controls to navigate to this page.
This page allows you to select which traps logs should be captured. Select the applicable logs and select
Apply.
11/5/04
90-100831-300 Rev 2Alcatel OmniAccess Wireless Access Point Quick Installation Guide 111
SNMP Trap Receiver > New
The name of the server where the traps are sent.
The IP address of the server.
Status must be enabled for the SNMP traps to be sent to the receiver.
SNMP Trap Receiver > Edit
SNMP Trap Controls
(SNMP Trap Receiver >
Range
SNMP Trap Receiver > New
New).