Alcatel OmniAccess Wireless System 2.1 Product Manual page 848

Table of Contents

Advertisement

Step 2: Configuring the OmniAccess AP 1200 or 1250 Before
Installation
Step 2: Configuring the OmniAccess AP 1200 or 1250 Before Installation
The following procedures are designed to make sure that your OmniAccess AP 1200 or 1250 physical
installation goes smoothly and that initial operation is as expected. If you are unable to prepare your
OmniAccess AP 1200 or 1250 for deployment, this Step also describes RMA (Return Material Authoriza-
tion) procedures.
Note:
BEFORE deploying the OmniAccess AP 1200 or 1250 in its final location.
Preparing a Version 2.0 OmniAccess AP 1200 or 1250
OmniAccess Wireless System
If you are unable to perform this procedure, refer to the RMA Procedures section in the Alcatel Omni-
Access Wireless Product Guide.
Preparing a Version 2.0 OmniAccess AP 1200 or 1250
If your OmniAccess AP 1200 or 1250 has Alcatel OmniAccess Operating System 2.0 or a later version
loaded on it, continue with this procedure.
Note:
1200 or 1250 to interoperate with a version 2.0 Alcatel OmniAccess Switch or
Appliance.
Configuration Setup
Configuration Setup
Does My OmniAccess AP 1200 or 1250 Qualify for this Procedure?
If your 2.0 or later version later OmniAccess AP 1200 or 1250(s) cannot be configured for any
other reason using the following procedure, refer to RMA Procedures in the Alcatel OmniAccess
Wireless Product Guide.
Configuration Steps for an OmniAccess AP 1200 or 1250
1.
Configure the Alcatel OmniAccess Switch or Appliance in LWAPP Layer 3 Mode and make sure
its DS Port is connected to the network. Use CLI, Web Browser and/or ACS procedures as
described in the Alcatel OmniAccess Switch or Appliance Quick Install Guide and the Alcatel
OmniAccess Wireless Product Guide.
11/5/04
Step 2: Configuring the OmniAccess AP 1200 or 1250 Before Installation
90-100831-300 Rev 2Alcatel OmniAccess Wireless Access Point Quick Installation Guide
Perform the following procedure on each OmniAccess AP 1200 or 1250
This procedure assumes that you are preparing a version 2.0 OmniAccess AP
for installation in a Version 2.0 Alcatel
Preparing a Version 2.0 OmniAccess AP 1200 or 1250
Does My OmniAccess AP 1200 or 1250 Qualify for this Procedure?
Configuration Steps for an OmniAccess AP 1200 or 1250
5

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the OmniAccess Wireless System 2.1 and is the answer not in the manual?

Table of Contents