Configure <Ipaddr> > 802.11A Rrm Intervals - Alcatel OmniAccess Wireless System 2.1 Product Manual

Table -
Load Thresholds
Parameter
Max Clients
RF Utilization (%)
Throughput Threshold
(bps)
Table -
Other Thresholds
Parameter
Interference Thres (%)
Noise Threshold (dBm)
Command Buttons
•
Save: Save the current settings.
•
Audit: Discover the present status of this AP.
Configure <IPaddr> > 802.11a RRM Intervals
Use CONFIGURE/Switches, click an IP address under the IP Address column, then on the left
sidebar menu select 802.11a/RRM Intervals to access this page.
Note that the Standalone WPS Alcatel OmniAccess Wireless System described in About the Alcatel
OmniAccess Wireless System in the Alcatel OmniAccess Wireless Product Guide does not support these
parameters.
This page allows you to specify 802.11a RRM interval parameters:
Table -
802.11a RRM Intervals
Parameter
Template Applies
Signal Measurement Interval
Noise Measurement Interval
Load Measurement Interval
Coverage Measurement
Interval
11/5/04
90-100831-300 Rev 2Alcatel OmniAccess Wireless Access Point Quick Installation Guide 212
(1 to 75) Maximum number of clients currently associated with the Alcatel
OmniAccess Switch or Appliance.
802.11a or 802.11b/g RF utilization threshold between 0 and 100 percent.
Between 1000 and 10000000 bytes per second.
(0 to 100%) Foreign 802.11a interference threshold between 0 and
100 percent.
Noise threshold between -127 and 0 dBm.
User-defined template name currently applied.
The interval (in seconds) for strength measurements at each
OmniAccess AP 1200 or 1250. Default is 300 seconds.
The interval (in seconds) for noise and interference measure-
ments at each OmniAccess AP 1200 or 1250. Default is
300 seconds.
The interval (in seconds) for load measurements at each
OmniAccess AP 1200 or 1250. Default is 300 seconds.
The interval (in seconds) for coverage measurements at each
OmniAccess AP 1200 or 1250. Default is 300 seconds.
Configure <IPaddr> > 802.11a RRM Intervals
Description
Description
Configure <IPaddr> > 802.11a RRM Intervals
Description