Config Switchconfig Commands; Config Switchconfig Flowcontrol; Config Switchconfig Mode - Alcatel OmniAccess Wireless System 2.1 Product Manual

Related Commands

CONFIG SWITCHCONFIG COMMANDS

Use the following config switchconfig commands:
•

config switchconfig flowcontrol

•

config switchconfig mode

config switchconfig flowcontrol
To enable or disable 802.3x flow control, use the config switchconfig flowcontrol command.
>config switchconfig flowcontrol [enable/disable]
Syntax
Defaults
Examples
Related Commands
config switchconfig mode
To configure LWAPP transport mode for Layer 2 or Layer 3, use the config switchconfig flowcontrol
command.
>config switchconfig mode [L2/L3]
Syntax
Defaults
Examples
Related Commands
config syslog
config syslog
To send or disable sending system logs, use the config syslog command.
>config syslog [<ipaddr>/disable]
Syntax
Defaults
11/5/04
90-100831-300 Rev 2Alcatel OmniAccess Wireless Access Point Quick Installation Guide 146
show spanningtree switch, config spanningtree switch bridgepriority, config
spanningtree switch forwarddelay, config spanningtree switch hellotime, config
spanningtree switch maxage, config spanningtree port mode
config switchconfig flowcontrol
config
switchconfig
flowcontrol
[enable/disable]
Disabled
>config switchconfig flowcontrol enable
show switchconfig
config switchconfig mode
config
switchconfig
mode [L2/L3]
L3
>config switchconfig mode L3
show switchconfig
config
syslog
<ipaddr>
disable
Disable
config switchconfig
Configure parameters.
Alcatel OmniAccess Switch or Appliance parameters.
Flow control.
Turn on/off.
Configure parameters.
Alcatel OmniAccess Switch or Appliance parameters.
Layer 2 or Layer 3 mode.
Configure parameters.
System logs.
Specify an IP Address to send logs.
Disable logs
config switchconfig