Configuring The Acs Database; Adding Devices To The Acs Software Database - Alcatel OmniAccess Wireless System 2.1 Product Manual

Configuring the ACS Database

•

Adding Devices to the ACS Software Database

-
Manually Adding an Alcatel OmniAccess Switch or Appliance to ACS
•
Adding a Campus Map to the ACS Database
•
Adding an Outdoor Area to a Campus
•
Adding a Standalone Building to the ACS Database
•
Adding Floor Plans to a Standalone Building
•
Adding Floor Plans to a Campus Building
•
Adding Floor Plans to a Standalone Building
•
Adding APs to Floor Plan and Open Area Maps
•
Monitor Predicted Coverage (RSSI)
•
Monitor Channels on Floor Map
•
Monitor Tx Power Levels on Floor Map
•
Monitor Coverage Holes on Floor Map
•
Monitor Users on Floor Map
•
Monitor Clients From Floor Map
Adding Devices to the ACS Software Database
When you use ACS Software for the first time, the Network Summary page shows that the Coverage
Areas, Most Recent Rogue APs, the Top 5 APs, and the Top 5 Coverage Holes database is empty, as
shown in the following figure. The following figure also shows that there are no clients connected to the
Alcatel OmniAccess Wireless System at this time.
Figure -
Network Summary for Unconfigured ACS Software Database
11/5/04
90-100831-300 Rev 2Alcatel OmniAccess Wireless Access Point Quick Installation Guide 140
Configuring the ACS Database
Adding Devices to the ACS Software Database
Configuring the ACS Database