A Ap Interfaces > Details - Alcatel OmniAccess Wireless System 2.1 Product Manual

Table -
802.11 General Parameters (Continued)
Parameter
AP ID
Profile Parameters
Globally Controlled
Interference
(0 to 100%)
Clients (1 to 75)
Noise (-127 to 0 dBm)
Coverage (3 to 50 dBm)
Utilization (0 to 100%)
Coverage Exception
Level (0 to 100%)
Data Rate
(1 to 1000 Kbps)
Client Min Exception
Level (1 to 75)
Command Buttons
•
Back: Return to the previous window.
•
Apply: Data is sent to the Alcatel OmniAccess Switch or Appliance and made to take effect, but
not preserved across a power cycle; these parameters are stored temporarily in volatile RAM.
•
Help: Request that the help page be displayed in a new browser window.
802.11a AP Interfaces > Details
Use WIRELESS/Access Points/802.11a Radios and then Details to navigate to this page.
This page lists primarily read-only attributes of the selected OmniAccess Radio.
11/5/04
90-100831-300 Rev 2Alcatel OmniAccess Wireless Access Point Quick Installation Guide 62
Displays the OmniAccess AP 1200 or 1250 identification number
automatically assigned by the Alcatel OmniAccess Switch or Appliance.
You cannot change the following parameters if the Profile Param-
Note:
eters Globally Controlled checkbox is selected.
Foreign 802.11a or 802.11b/g interference threshold between 0 and
100 percent. Globally set on
802.11b/g Global Parameters > Auto RF
Client threshold between 1 and 75 clients. Globally set on
Parameters > Auto RF
pages.
Noise threshold between -127 and 0 dBm. Globally set on
Parameters > Auto RF
pages.
802.11a or 802.11b/g coverage threshold between 3 and 50 dBm.
Globally set on 802.11a Global Parameters > Auto RF
Global Parameters > Auto RF
802.11a or 802.11b/g RF utilization threshold between 0 and 100
percent. Globally set on
802.11b/g Global Parameters > Auto RF
Coverage exception level between 0 and 100 percent. Globally set on
802.11a Global Parameters > Auto RF
> Auto RF pages.
802.11a or 802.11b/g throughput threshold between 1 Kbps and
1000 Kbps. Globally set on
802.11b/g Global Parameters > Auto RF
Client minimum exception level. Globally set on
eters > Auto RF and 802.11b/g Global Parameters > Auto RF
802.11a AP Interfaces > Details
Description
802.11a Global Parameters > Auto RF
pages.
and 802.11b/g Global Parameters > Auto RF
and 802.11b/g Global Parameters > Auto RF
pages.
802.11a Global Parameters > Auto RF
pages.
and 802.11b/g Global Parameters
802.11a Global Parameters > Auto RF
pages.
802.11a AP Interfaces > Details
and
802.11a Global
802.11a Global
and 802.11b/g
and
and
802.11a Global Param-
pages.