Alcatel OmniAccess Wireless System 2.1 Product Manual page 627

Table -
Received Packets with MAC Errors (Continued)
Parameter
FCS Errors
Table -
Transmit Discards
Parameter
Single Collision Frames
Multiple Collision Frames
Deferred Transmissions
Late Collisions
Excessive Collisions
•
Alarms: Click to go to the
•
Events: Click to go to the
Table -
Ether Stats
Parameter
CRC Align Errors
Undersized Packets
Oversize Packets
Ether Stats Collisions
11/5/04
90-100831-300 Rev 2Alcatel OmniAccess Wireless Access Point Quick Installation Guide 48
The total number of packets received that had a length (excluding
framing bits, but including FCS octets) of between 64 and 1518
octets, inclusive, but had a bad Frame Check Sequence (FCS) with
an integral number of octets.
A count of the number of successfully transmitted frames on a
particular interface for which transmission is inhibited by exactly one
collision.
A count of the number of successfully transmitted frames on a
particular interface for which transmission is inhibited by more than
one collision.
A count of frames for which transmission on a particular interface
fails due to deferred transmissions.
A count of frames for which transmission on a particular interface
fails due to late collisions.
A count of frames for which transmission on a particular interface
fails due to excessive collisions.
Monitor Alarms page.
Monitor Alarm > Events
The number of incoming packets with the Checksum (FCS) alignment
error. This represents a count of frames received on a particular
interface that are not an integral number of octets in length and do
not pass the FCS check. Received frames for which multiple error
conditions obtain are, according to the conventions of IEEE 802.3
Layer Management, counted exclusively according to the error status
presented to the LLC.
The total number of packets received that were less than 64 octets in
length (excluding framing bits but including FCS octets).
The total number of frames that exceeded the maximum permitted
frame size. This counter has a maximum increment rate of 815
counts per second at 10 Mbps.
The number of packets with collision errors.
Monitor Switches > <IPaddr> > Ports > n
Description
Description
page.
Description