Config Snmp Syscontact; Config Snmp Syslocation; Config Snmp Trapreceiver Commands; Config Snmp Trapreceiver Create - Alcatel OmniAccess Wireless System 2.1 Product Manual

Examples
Related Commands

config snmp syscontact

To set the SNMP system contact name, use the config snmp syscontact command.
Syntax
Defaults
Examples
Related Commands

config snmp syslocation

To set the SNMP system location name, use the config snmp syslocation command.
>config snmp syslocation <location>
Syntax
Defaults
Examples
Related Commands

CONFIG SNMP TRAPRECEIVER COMMANDS

Use the following config snmp trapreceiver commands:
•

config snmp trapreceiver create

•
config snmp trapreceiver delete
•
config snmp trapreceiver mode
config snmp trapreceiver create
To add server to receive a SNMP traps, use the config snmp trapreceiver create command. The IP
Address must be valid for the command to add the new server.
>config snmp trapreceiver create <name> <ipaddr>
Syntax
11/5/04
90-100831-300 Rev 2Alcatel OmniAccess Wireless Access Point Quick Installation Guide 139
>config snmp community mode disable public
show snmp community, config snmp community accessmode, config snmp
community create, config snmp community delete, config snmp community
ipaddr
config snmp syscontact
>config snmp syscontact <contact>
config
snmp
syscontact
<contact>
(none)
>config snmp syscontact Alcatel_administrator
show snmpcommunity
config snmp syslocation
config
snmp
syslocation
<location>
(none)
>config snmp syslocation Building_2a
show snmpcommunity
config snmp trapreceiver create
config
snmp
trapreceiver
Configure parameters.
SNMP parameters.
System contact.
Name (Up to 31 alphanumeric characters).
Configure parameters.
SNMP parameters.
System location.
Name (Up to 31 alphanumeric characters).
config snmp trapreceiver
Configure parameters.
SNMP parameters.
SNMP trap server parameters.
config snmp syscontact