Alcatel OmniAccess Wireless System 2.1 Product Manual page 907

-
IP address of the default DHCP Server that will supply IP Addresses to clients, the
Alcatel OmniAccess Switch or Appliance Management Interface, and optionally to the
Service Port Interface.
-
LWAPP Transport Mode, LAYER2 or LAYER3 (refer to Layer 2 and Layer 3 Operation in
the Alcatel OmniAccess Wireless Product Guide).
-
Virtual Gateway IP Address: one fictitious, unassigned IP address (such as 1.1.1.1) to
be used by all Alcatel OmniAccess Wireless System Layer 3 Security and Mobility
managers.
-
Alcatel Mobility Group (RF Group) Name, if required.
-
802.11 Network Name (SSID) for WLAN 1. This is the default SSID that the
OmniAccess AP Access Points and Alcatel OmniAccess Remote Edge Access Points, or
OmniAccess 1200R APs, broadcast when they associate with the Alcatel OmniAccess
Switch or Appliance.
-
Whether or not to allow Static IP Addresses for clients.
* Yes = more convenient, but lower security (session can be hijacked), clients can
supply their own IP Address, better for devices that cannot use DHCP.
* No = less convenient, higher security, clients must use DHCP for an IP Address,
works well for Windows XP devices.
-
When you are configuring a RADIUS server, the server IP address, communication port,
and Secret.
-
Country Code for this installation. Refer to Configuring the Alcatel OmniAccess Switch
or Appliance and Alcatel OmniAccess Wireless System Supported Regulatory Domains
in the Alcatel OmniAccess Wireless Product Guide.
-
802.11b network enabled or disabled?
-
802.11a network enabled or disabled?
-
802.11g network enabled or disabled?
-
OmniVista AirView Software (Auto-RF) enabled or disabled?
Continue with Step 2: Determining a
11/5/04
90-100831-300 Rev 2Alcatel OmniAccess Wireless Access Point Quick Installation Guide
Location.
Alcatel OmniAccess Switch or Appliance Hardware
8