Alcatel OmniAccess Wireless System 2.1 Product Manual page 235

Table -
Error Messages and Descriptions (Continued)
Error Message
STP_NEWROOT
STP_TOPOLOGY_CHANGE
IPSEC_ESP_AUTH_FAILURE
IPSEC_ESP_REPLAY_FAILURE
IPSEC_ESP_POLICY_FAILURE
IPSEC_ESP_INVALID_SPI
IPSEC_OTHER_POLICY_FAILURE
IPSEC_IKE_NEG_FAILURE
IPSEC_SUITE_NEG_FAILURE
IPSEC_INVALID_COOKIE
RADIOS_EXCEEDED
SENSED_TEMPERATURE_HIGH
SENSED_TEMPERATURE_LOW
TEMPERATURE_SENSOR_FAILURE
TEMPERATURE_SENSOR_CLEAR
POE_CONTROLLER_FAILURE
MAX_ROGUE_COUNT_EXCEEDED
SWITCH_UP
SWITCH_DOWN
RADIUS_SERVERS_FAILED
11/5/04
90-100831-300 Rev 2Alcatel OmniAccess Wireless Access Point Quick Installation Guide 194
Description
Informational message.
Informational message.
Check WLAN IPSec configuration.
Check for attempt to spoof IP Address.
Check for IPSec configuration mismatch between
WLAN and client.
Informational message.
Check for IPSec configuration mismatch between
WLAN and client.
Check for IPSec IKE configuration mismatch between
WLAN and client.
Check for IPSec IKE configuration mismatch between
WLAN and client.
Informational message.
Maximum number of supported OmniAccess Radios
exceeded - Check for Alcatel OmniAccess Switch or
Appliance failure in the same Layer 2 network or add
another Alcatel OmniAccess Switch or Appliance.
Check fan, air conditioning and/or other cooling
arrangements.
Check room temperature and/or other reasons for
low temperature.
Replace temperature sensor ASAP.
Temperature sensor is operational.
Check Direct-Connect APs - possible serious failure
detected.
The current number of active rogues has exceeded
system threshold.
Alcatel OmniAccess Switch or Appliance is
responding to SNMP polls.
Alcatel OmniAccess Switch or Appliance is not
responding to SNMP polls, check Alcatel OmniAccess
Switch or Appliance and SNMP settings.
Check network connectivity between RADIUS and
the Alcatel OmniAccess Switch or Appliance.
Troubleshooting Tips