Viewing Network Status - Alcatel OmniAccess Wireless System 2.1 Product Manual

•
Enter <CTRL-Z> to return to the root level.
•
From the root level, you can enter the whole command name. For instance, you can enter:
>config prompt "Ent1"
to change the system prompt to
•
To save your changes from active working RAM to non-volatile RAM (NVRAM) so they are
retained upon reboot, use the save config command at the CLI root level.
•
To reset the Alcatel OmniAccess Switch or Appliance without logging out, use the reset system
command at the root level of the CLI tree structure.
•
When you are done using the CLI console, navigate to the root level and enter logout. You will
be prompted to save any changes you have made from the active working RAM to the
non-volatile RAM (NVRAM).

Viewing Network Status

Use the following Command Line Interface
an Alcatel OmniAccess Switches and
•
Use the show client commands to display client information for each OmniAccess AP 1200 or
1250 802.11a and 802.11b/g RF coverage area, to display detailed information for a client
connected through a particular OmniAccess AP 1200 or 1250, and display a summary of clients
connected through the Alcatel OmniAccess Wireless System:
>show client ap [802.11a/802.11b] <OmniAccess AP 1200 or 1250>
>show client detail <MAC addr>
>show client summary
If you need to, use the config client deauthenticate command to deauthenticate an indi-
vidual <MAC address>.
•
Use the show rogue-ap summary and show rogue-ap detail commands to discover
Rogue APs on the subnet. If necessary, use the config rogue-ap acknowledged, config
rogue-ap alert, and config rogue-ap known commands to mark the Rogue APs in the
Alcatel OmniAccess Wireless System database.
•
In general, use the show commands to view the Alcatel OmniAccess Wireless System status.
•
To test a link to a MAC address, use the linktest command at the CLI root level. Note that
linktest does not work for IPSec links and does not work from OmniAccess AP Access Points
or Alcatel OmniAccess Remote Edge Access Points (OmniAccess 1200R APs).
•
To ping an IP Address, use the ping command at the CLI root level.
Continue with Using the Alcatel OmniAccess Wireless System
11/5/04
90-100831-300 Rev 2Alcatel OmniAccess Wireless Access Point Quick Installation Guide 101
.
Ent1 >
Viewing Network Status
commands to view the status of the network controlled by
Appliances.
CLI.
Viewing Network Status