Alcatel OmniAccess Wireless System 2.1 Product Manual page 145

•
Use the show country command to view the Alcatel OmniAccess Switch or Appliance country
regulatory domain.
•
If necessary, set the Alcatel OmniAccess Switch or Appliance regulatory domain by entering:
>config country <domain>
Where <domain> =
-
US (United States of America), which allows 802.11b and 802.11g operation and
802.11a Low, Medium, and High bands.
-
USL (US Low), which allows 802.11b and 802.11g operation and 802.11a Low and
Medium bands. (Used for legacy 802.11a interface cards that do not support 802.11a
High band.)
-
AU (Australia), which allows 802.11a and 802.11b/g.
-
AT (Austria), which allows 802.11a and 802.11b/g.
-
BE (Belgium), which allows 802.11a and 802.11b/g.
-
CA (Canada), which allows 802.11b/g.
-
DK (Denmark), which allows 802.11a and 802.11b/g.
-
FI (Finland), which allows 802.11a and 802.11b/g.
-
FR (France), which allows 802.11a and 802.11b/g.
-
DE (Germany), which allows 802.11a and 802.11b/g.
-
GR (Greece), which allows 802.11b/g.
-
IE (Ireland), which allows 802.11a and 802.11b/g.
-
IN (India), which allows 802.11a and 802.11b.
-
IT (Italy), which allows 802.11a and 802.11b/g.
-
JP (Japan), which allows 802.11a and 802.11b/g.
-
KR (Republic of Korea), which allows 802.11a and 802.11b/g.
-
LU (Luxembourg), which allows 802.11a and 802.11b/g.
-
NL (Netherlands), which allows 802.11a and 802.11b/g.
-
PT (Portugal), which allows 802.11a and 802.11b/g.
-
ES (Spain), which allows 802.11a and 802.11b/g.
-
SE (Sweden), which allows 802.11a and 802.11b/g.
-
GB (United Kingdom), which allows 802.11a and 802.11b/g.
•
Continue with the next parameter.
Supported 802.11a and 802.11b/g Protocols
The 802.11a and 802.11b/g protocols can be independently enabled or disabled.
•
Use the show sysinfo command to view the 802.11a and 802.11b/g enabled/disabled status.
•
Make sure these protocols are configured to agree with your wireless network plan and to
comply with the Country regulatory domain entered in the previous step using the following
commands:
>config 802.11a enable network
>config 802.11a disable network
11/5/04
90-100831-300 Rev 2Alcatel OmniAccess Wireless Access Point Quick Installation Guide 104
Supported 802.11a and 802.11b/g Protocols
Configuring System Parameters